Reply To: Framing Tool

[John Brock]

Terry-

First – to customize your headers, choose the Configure Materials icon in the toolstrip (eye dropper), then choose Header and Sections (metric in your case I assume) – you may then customize the various sizes you like, then Save.

Second – angled walls are tricky and a known limitation. What I have been doing is modeling the walls from corner to corner in the angle, add my openings and that is usually “close enough” – If I need precise or exact cuts, I have to edit the walls manually, just remember if you edit the wall manually (group), then IF you edit the wall again using Framer, it will revert back to Framer parameters. I am open to suggestions on how to improve this issue.