Framer- Component @0.0

[Maury Thirlwell]

Hi John,
On some walls I am getting an @0.0 added to the component definition. It does not seem to be consistent from wall to wall or when in the wall from stud to stud. I am not sure what I may doing wrong, or if some uses of the tool causes this to happen. So, when I am doing a take-off I have 2 definitions for what I think is the same component, one without the @0.0 and one with. Whenever you have time. Thanks.

Thanks
Maury

Sketchup 2022
mthirlwell
estimates@maurythirlwell.com

[John Brock]

Hi Maury,
I have not seen this before and have sent this to our developer for input. I will email you directly to start a dialog there and resolve it.
Thanks!
John Brock

[Author]

Posts